New computer time !!

I decided to rebuild my old system for tink and buy me a new setup.. 2.5k later its done !!!

I picked up a 850 evo 512g,970evga,corsair 105 cooler for my old system. Which is a 8320 amd with 32gigs of ram. I been
having this strange issue with the system for years where i get no video output on start up. After replacing the mb/ps
i finally came to the conclusion it was the video card. Which was a 7970. The card was wc and had lived
a hard life as a bitminer in its early months. Still though only 3 years out of it left me really ticked off.

After i got that sorted out and stuck together for tink i started gathering my pieces.

I was really torn on how i wanted to go with this build. Did i want to go with the 6core stuff that intel has or
strike out with the new skylake setup. In the end i went with the skylake setup. Mostly over MB selection.

System consists of

Gigabyte z170x Gaming 7
32gigs of memory
950 nvme ssd 512g -- sucker fast !!
980 gtx evga hydro card which i brought used
Phanteks Enthoo primo case to stuff it all in -- HUGE case
Dell s2716d 27" 1440p -- So impressed with this monitor

I wanted to purchase all new wc parts but i was running low on funds so just
moved my old wc parts over.
The WC parts with new tubing went on so smooth. Generally it can take a lot of time to figure everything out
and then run the tubing burp/bleed it/leak test it

I spent less then 4 hours from start to finish on the tubing then burping the system. To put that into perceptive
i normally figure 24 hours for all that. The bay/pump setup i have was a nightmare to use the first time i ever
did a system with it. This time around it was unreal how easy it was.

Its ok cause when i turned the system on for the first time it wouldn't post. Just a cycle of reboots. Code was 55
and it was 5 beeps when i plugged a speaker in. To make a long story short. Turned out the bios was faulty. Lucky for me
gigabytes have a secondary one and i was able to flip a switch and the system booted up. We just not talk about all
the BS i went thru before i remembered about the secondary bios. :) Also had sound issues. Turned out to be a bad sound
card + amp lost a channel.

The only issue i not resolved is a very slow boot up from bios to when windows finally starts loading. I have a few
suspicions on that but i going to let it slid for now. Its super fast load from when windows logo appear till i am on
desktop Like 5 secs or less. Just sets at a flashing cursor after the bio screen for about 15 secs. Driving me nuts.

http://i531.photobucket.com/albums/d...psh2loncxp.jpg

Back side of the mess of wires. Really nice wire management options if i wanted to take the time. At some point i might pull it apart and
really wire it up with idea of having a super clean install.

http://i531.photobucket.com/albums/d...psuqiu5xzn.jpg

Topside pick of the Res/pump combo. I love compression fitting !! U can just make out the fill port. I used a long piece
of tubing and a funnel. Way easier then it was on my silverstone tj09 case.

http://i531.photobucket.com/albums/d...pso5et6xyr.jpg

Lost one of the monitor setup. 27inch/21 inch. Both running 1920x 1080p. I not tried out the 1440p in anything yet.

http://i531.photobucket.com/albums/d...psrfw2fi2a.jpg